Gledhill Stainless Lite Plus 250L Indirect Unvented Cylinder Stainless Steel - PLUIN250

Gledhill Stainless Lite Plus 250L Indirect Unvented Cylinder Stainless Steel - PLUIN250An unvented cylinder for use with a conventional boiler and electricAvailable in 8 sizes ranging from 90 litres to 400 litres, with the largest model capable of satisfying the hot water demands of a property with 3 bathrooms and 3 separate shower rooms. All Available from TDL onlineThe indirect range has a high efficiency corrugated tube coil which is connected to a conventional boiler to heat the cylinder of water. The coil’s corrugated design gives much faster recovery times than can be achieved with plain tube coils.All models have a temperature and pressure relief valve which is factory set at 6 bar and 95 degrees celsius.(Please note all indirect models come with an on-peak back-up immersion but only the 250, 300 and 400 litre models are supplied with an additional off-peak immersion.)Features & BenefitsDesigned for use with gas or oil boilers, either sealed system or open ventedHigh efficiency corrugated coil maximises heat transfer to the cylinder of waterCorrugated coil provides faster reheat times compared to plain coil3kW incoloy immersion heater for emergency back-up90° elbow supplied as standard25 Year WarrantyCapacity 248 litresHeight 1744mmDiameter 550mmWeight – empty 20KG, full 111KGErp Rating AHeat up time 17 minutesSecondary return – YesMaximum inlet pressure 12 BarPressure reducing valve 3 BarMax working pressure 6 Bar50mm insulation to reduce heat lossLightest cylinder on the marketWhat Comes with the Cylinder:1 x Stainless Lite Plus Unvented cylinder2 x 3KW Incoloy 825 immersion heaterExpansion vessel with integral brackets supplied in the G3 kitLift up temperature and pressure relief valve3 Bar inlet controlCompression fittings supplied with unvented products90 degree elbow supplied on the hot water draw off to reduce installation timeGledhill Stainless Lite Plus is covered by Section G3 of the Building Regulations (England and Wales). Technical Standard P3 (Scotland) and Building Regulation P5 (Northern Ireland). Compliance can be achieved via a Competent Person Self Certification Scheme or notification of installation to the Local Authority Building Control Department.